Getting back into sewing

I’m pretty sure you folks all know I love to sew.  I’ve rambled about it a number of times on the blog.  Unfortunately, I haven’t really done much of it lately — largely because I don’t really have space to permanently set up my sewing machine.  It’s kind of a pain in the butt to set my sewing space up in the kitchen, sew for a few hours, and then take it all back down because we need to eat.  And unless I want to try to sew standing up, with the sewing machine perched on my giant dresser, there’s not really space to set it up in my craft room.

Not pictured: the messy bed with the cat sprawled on top of it, or the huge dresser covered in a mess of craft supplies.

Eventually I’ll have the space, since I’m planning on getting rid of the giant dresser (which takes up nearly an entire wall) and getting a much more reasonably sized one from Ikea at some point, and rearranging the furniture that’s left.  However, that’s going to involve some help from friends and a trip up to Fishers to get a new dresser, and a number of other things that I can’t quite get done right away.

In the meantime, I figured out a space where I can semi-permanently set up my sewing machine!  You’ll probably laugh, but hey, it’s working out pretty well for me.

My tiny sewing studio, complete with Super Mario trash can, motorcycle, and ugly garage floor. (I never said this was a glamorous studio!)

Yes, I’ve set up my sewing machine in the garage, of all places. Sure, it smells a little bit like motorcycle fumes when it gets warm in there, but I don’t mind it.  I have both my sewing machine and my ironing board set up at the same time, and can switch between them easily — which is wonderful.  When I try to set everything up in the kitchen, inevitably I end up tripping over something or knocking something over.  I used to flop the ironing board on top of the washer and dryer, but since Ross and I got new ones last year with rounded tops, I can’t quite iron in the laundry room anymore.

It’s actually not so bad, sewing in the garage.  Sure, it doesn’t look glamorous at all, but since when do all craft rooms have to be shiny and pretty and Instagram-worthy?  And I have the added benefit of being able to enjoy lots of fresh air, since I can just open up the garage door and practically be sewing outside.

Lapis: “can I help? 😀 “

Plus, that means I can sew with New Lapis! Who I’ll probably ramble about in more detail at a later date.  After all, she is The Crafty Nerdmobile!  (And once a month, she’s Lappy the LARPmobile too.)

Anyway, I’ve managed to put my sewing studio to good use so far — I’ve started work on a disappearing 9-patch quilt, and I’m to the part where I can start sewing the completed squares together.

The start of the disappearing 9-patch square — this is before I chopped it all up.

I’m really impressed with how these squares are coming out, on most of them the seams are lining up perfectly.  I learned some new quilting techniques (or, more accurately, ironing techniques) that really helped with this.  I didn’t know until recently that when you’re working with quilt squares, you shouldn’t iron them like you’d typically iron a shirt or other sewing projects.  Instead, you just flop the iron down on the seam you want to press flat and let gravity do the work.  I’ve been setting the iron on the seam for a few seconds, then lifting it and setting it further down, and it’s working out really well for me.

And here’s the square after! Doesn’t it look fantastic?

I think once I’m finished with this quilt, I might actually get working on the Sailor Moon quilt again – which also might end up being a disappearing 9-patch as well.  This pattern is fun, and ends up looking really nice when it’s done.  Not sure what I’ll do with either of these quilts when they’re finished, as I’m starting to run out of places to put them, but I’ll figure it out eventually.

I missed sewing.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.